Rigging Instructions

Race Ski & Speed Spec

1. Mount binding in a straight line, down the center of the ski. DO NOT angle the rear binding.

2. Use stainless steel, Phillips, oval head, sheet metal screws, #10 X 1 3/4" for most "race" type bindings. The screws should penetrate the ski 1 inch plus or minus.

3. Pre drill 3/4 inch into the ski with a 3/32 inch bit; counter sink the laminate just a little.

4. When mounting slalom type bindings such as ours or HO’s, use #8 X 1 inch, stainless steel, pan head, Phillips sheet metal screws.

5. Pre drill 3/8 inch into ski with a 3/32 inch bit; counter sink the laminate just a little.

6. The ski is marked for binding placement. Set the rear of the front binding at the mark. Place back binding very close. Your back toe should be within 1/2 inch of your front binding.

* This ski banks and turns so well that any part of a binding, such as a buckle, that extends beyond the side of the ski will pick up water and interfere with your turn!

Made in the U.S.A. bob@maherajah.com